Tai'an Taishan Rongda Construction Technology Co., Ltd.
Contact: Manager Li
Address: Great Wall Road, Tai'an City, Shandong Province
Tianlong International Building
a. Lift the plastic mold shell to the formwork and spread it evenly to avoid some excessive loads.
b. The two plastic workers should be placed together to place the plastic mold shell, and it should be accurately positioned according to the grid. Always check whether the bottom of the plastic mold shell and the top surface of the template are tightly connected after being in place, and avoid showing a large gap.
c. After placing the plastic mold shells, fill the gaps between the mold shells with fillers such as bamboo rubber sheets, wooden slats, and extruded slats. The filler can be fixed on the formwork with small nails to avoid the filler from warping. The main effect of this method is to avoid the horizontal displacement of the plastic formwork under the effect of the side pressure of the concrete.
d. After laying the plastic mold shell, a special person should be organized to inspect this process to ensure the straightness of the rib beam and the uniform cross section of the rib beam. Adhesive tape is used to seal the template at the in-situ pouring position on the four corners of the mold shell.
Laying pipelines and pre-buried:
a. The horizontally laid electric tubes and cassettes should be placed in the cast-in-place plate on the top of the mold shell as much as possible. After the plastic mold shell is removed, the cassette is exposed.
b. Vertical water pipes, warm pipes and vertical pipe wells should be placed in the solid concrete area of the floor surrounding the beams and columns as much as possible.